Oil-fired boiler safety valve replacement is a safety valve means for comparing the use of oil-fired boilers, but for various reasons, of course, if too long, then the safety valve, safety valve when doing manual drain, occurs when the valve does not jump start exhaust valve when the core back seat lax steam leakage, the safety valve should be replaced. Procedure: (1) pressing the stop button boiler, the boiler is under a shutdown state, stop the pump, the pump is stopped to stop the blower inlet valves closed sub-cylinder, boiler exhaust valve opening, exhaust open the safety valve, after venting, the safety valve to close; (2) to the fuel feed pump then starts boiler Feed, the drain valve opens the drain, opening the inside of the drain valve, the drain valve opening outward, closing the drain valve outside, inside the drain valve closed, open 2nd outer drain valve, 2nd outer drain valve closed, water-cooled pot until the boiler pressure drops to zero, the safety valve is removed; (3) prepared by qualified and check the validity of the exchange valve on. These are the oil-fired boiler safety valve replacement hope for your help. Pressure gauge oil-fired boilers to replace oil-fired boiler during operation, appears when the gauge back to zero to do the test, the pointer appears not return to zero, and exceed the allowable time error, dial gauge cover and obscure, often beating pointer, when the leak, etc. in the table, replace the gauge. Oil-fired boiler Procedure: (1) the three-way valve in the pressure gauge to gauge the twist to the atmosphere, so that no inner pressure gauge; (2) removing the pressure gauge, the prepared by qualified and check the validity of put pressure gauge inside; (3) slowly twist to the three-way valve and pressure gauge trap interlinked; the new gauge into operation; more specific method is to replace the oil-fired boiler pressure gauge we want to help of course, if you have anything unclear in our online customer service is always happy to answer you.
The first way to extend the service life of a Fangkuai hot vaccum hotwater boiler is to use the Fangkuai boiler, because it is a hot water boiler, then, in the boiler, there must be a large amount of water, and when there is no water, it will be necessary to replenish the water in time at this time. Note, however, that there is no need for a one-off replenishment of a large amount of water, just a little less at each replenishment. In order to prevent the corrosion of the furnace body of the hot water boiler, it is better to add some oxygen-free water directly into the furnace during the process of water replenishment in order to prevent the corrosion of the furnace body of the hot-water boiler in order to prevent the corrosion of the furnace body. Second, if you want to In order to better protect hot water Fangkuai boilers, sodium sulfite and professional trisodium phosphate need to be added directly to the boiler. Not only in the use of the process needs to be maintained, in the absence of the same need for maintenance, if the shutdown time is longer, then, more attention to the maintenance of the problem. At the same time, in the maintenance time, different decommissioning time, need the maintenance method is also different.
These are the typical measures for boiler capacity: A capacity of 1 Boiler Horsepower = 34.5 Lbs/Hr steam output = 15.65 Kg/Hr Steam output = 33,479 Btu/Hr heat output = 9.81 kW heat output
Our company attaches great importance to the quality of wine, winemaking process steam requirements provided very strict, party fast boiler provides fully meet our needs, give us a brewery to provide strong support. --customer feedback
[email protected]
